|
[Sponsors] |
Warning: couldn't find neighbor across sliding interface ... reflecting |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 3, 2013, 05:32 |
Warning: couldn't find neighbor across sliding interface ... reflecting
|
#1 | |
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 13 |
Hello!
I run a case in HVAC system. first I solve the flow until achieved converge solution. then I inject some particle throw certain surfaces. By starting DPM iteration I got the following warnings" Quote:
Last edited by asal; April 3, 2013 at 08:59. |
||
April 4, 2013, 06:38 |
|
#2 |
Senior Member
SSL
Join Date: Oct 2012
Posts: 226
Rep Power: 14 |
The problem is with your mesh.
|
|
April 4, 2013, 08:59 |
|
#3 |
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 13 |
Well!!
No, as I mentioned the mesh has a great quality and I got converge solution. I found the problem by getting help from ANSYS company. they found that those error messages are known to be an issue in Fluent 14. Last edited by asal; April 4, 2013 at 11:37. |
|
October 24, 2016, 10:25 |
And the solution was...??
|
#4 |
Member
Join Date: Jul 2013
Posts: 84
Rep Power: 12 |
Hello asal!
The thread is very old now, but I am facing the same problem here. I wonder if you could please share the solution to the problem. Thanks in advance! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to use setField to create sphere | sega | OpenFOAM Pre-Processing | 38 | January 13, 2022 01:39 |
[swak4Foam] installing funkySetFields | prapanj | OpenFOAM Community Contributions | 65 | October 8, 2015 18:46 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
[Gmsh] discretizer - gmshToFoam | Andyjoe | OpenFOAM Meshing & Mesh Conversion | 13 | March 14, 2012 05:35 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 21:30 |