|April 15, 2013, 05:32||
Join Date: Apr 2013
Posts: 2Rep Power: 0
i try to simulate the injection of diesel in a dieselengine.
my problem ist that the injection stops too early and that the spray dont shape an uniform cone.
i hope you can understand my bad english.
|April 15, 2013, 11:33||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
when you specify injection, one of the properties are start time and end time. if you end time is 0. it will stop imediatly. put something like 1e09 so it never stops
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|Thread||Thread Starter||Forum||Replies||Last Post|
|Reference on atomization and spray modelling||alberto||OpenFOAM Running, Solving & CFD||1||September 14, 2012 13:14|
|CFD spray modelling||Kumar||FLUENT||1||September 14, 2012 12:56|
|HELP! post processing for spray modelling||hamish888||FLUENT||1||August 2, 2012 10:21|
|transient spray modelling||anand3984||CFX||2||May 23, 2012 06:03|
|Spray modelling||bharat05||Main CFD Forum||0||April 3, 2012 02:21|