|
[Sponsors] |
April 15, 2013, 06:32 |
Spray modelling
|
#1 |
New Member
tim
Join Date: Apr 2013
Posts: 2
Rep Power: 0 |
Hello,
i try to simulate the injection of diesel in a dieselengine. my problem ist that the injection stops too early and that the spray dont shape an uniform cone. i hope you can understand my bad english. thanks |
|
April 15, 2013, 12:33 |
|
#2 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
when you specify injection, one of the properties are start time and end time. if you end time is 0. it will stop imediatly. put something like 1e09 so it never stops
|
|
April 16, 2013, 05:05 |
|
#3 |
New Member
tim
Join Date: Apr 2013
Posts: 2
Rep Power: 0 |
yes i have
|
|
May 25, 2013, 15:22 |
|
#4 |
Member
Zacarias Carral
Join Date: Sep 2012
Posts: 35
Rep Power: 13 |
you have to check the injected mass and inlet velocity. Is it coherent?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reference on atomization and spray modelling | alberto | OpenFOAM Running, Solving & CFD | 1 | September 14, 2012 14:14 |
CFD spray modelling | Kumar | FLUENT | 1 | September 14, 2012 13:56 |
HELP! post processing for spray modelling | hamish888 | FLUENT | 1 | August 2, 2012 11:21 |
transient spray modelling | anand3984 | CFX | 2 | May 23, 2012 07:03 |
Spray modelling | bharat05 | Main CFD Forum | 0 | April 3, 2012 03:21 |