Define another cell zone
I am modelling a gas water heater for my FYP so i have do analysis on ansys 14.0. I have constructed the body and even the mesh, but unfortunately when i go into fluent it only give me a single option of cell zone conditions where as my geometry is of 2 concentric pipes, one with flue gases and other of water. Please help me in this regard. how can i separate the cell zone and define 2 different zones, one for each tubes?
|
In wch software u did meshing.?
|
i did meshing in ansys 14.0 build in meshing programme.
|
You can split mesh in fluent also..check in tutorial
|
thanks, can you provide me the link to the tutorial..?
|
Please refore screen shot
2 Attachment(s)
|
All times are GMT -4. The time now is 17:21. |