Error exporting data

agustinvo · April 20, 2013, 09:31

Hi,

I have this problem: I'm trying export some data from case files, and they are in a server (I've not the files, and after downloaded I can't open them because of the RAM of my PC). I know if I want to do this, I have to execute the journal with only one computer:

Quote:

/share/apps/Fluent.Inc/bin/fluent 3ddp -ssh -g -i dpt.2.jou > dpt.2.jou-${NB}-procs.out

But, when I run the journal, after selectioning the zones to export, FLUENT reports this:

Quote:

Warning: An error or interrupt occurred while reading the journal file.
Some commands may not have been completed.

Looking for a cause of this problem, I saw in a temporal file:

Quote:

Error: GENERAL-CAR-CDR: invalid argument [1]: improper list
Error Object: #f

I don't know why it is happening: I always did the same for exporting data. I attach my journal and temporal files

blackmask · April 21, 2013, 00:03

Check you journal file. The word 'secfluid' should be replaced by 'seccfluid'.

agustinvo · April 21, 2013, 09:13

Thank you! It was the first thing I should have seen! I decided to change the name in gambit meshing, but I didn't in the journal creation. Thanks again!

April 21, 2013, 00:03		#2
blackmask Senior Member Join Date: Aug 2011 Posts: 421 Blog Entries: 1 Rep Power: 21	Check you journal file. The word 'secfluid' should be replaced by 'seccfluid'. agustinvo likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ã€Helpã€‘"Error: Update_Time_Level: invalid data"	Chen	FLUENT	2	August 24, 2014 07:51
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 10:52
export data at nodes	Meenu	FLUENT	1	December 30, 2011 01:24
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
How to update polyPatchbs localPoints	liu	OpenFOAM Running, Solving & CFD	6	December 30, 2005 17:27

April 21, 2013, 09:13		#3
agustinvo Senior Member Agustín Villa Join Date: Apr 2013 Location: Alcorcón Posts: 313 Rep Power: 15	Thank you! It was the first thing I should have seen! I decided to change the name in gambit meshing, but I didn't in the journal creation. Thanks again!