|April 21, 2013, 08:51||
how to reduce incomplete particles?
Join Date: Feb 2013
Posts: 34Rep Power: 5
during particle tracking in my case, I got almost the whole release particles incomplete as you can see below:
DPM Iteration ....
number tracked = 60, escaped = 0, aborted = 0, trapped = 5, evaporated = 0, incomplete = 55, incomplete_parallel = 0
Parallel particle tracking concurrency: 21%
I increase the max. Number of steps to reduce the incomplete as it recommended in user manual, but nothing change!
Any suggestion in the case?
|April 21, 2013, 09:15||
Join Date: Oct 2010
Posts: 986Rep Power: 16
If it is a cyclone application you can read this about incomplete particles tracking:
Cyclone separator Simulation
[DPM problem] infinite particles loop in domain (twin cyclone - double cyclone))
This could be applied also to other models.
|Thread||Thread Starter||Forum||Replies||Last Post|
|GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh||gschaider||OpenFOAM||300||October 29, 2014 19:00|
|Problems building Paraview 3.12 on Gentoo Linux||pajot||OpenFOAM Installation||11||April 11, 2013 08:09|
|installing funkySetFields||igo||OpenFOAM||1||November 20, 2012 21:16|
|incomplete particles in DPM model||elah599||FLUENT||1||June 26, 2011 01:37|
|incomplete particles||jack||FLUENT||2||November 11, 2007 06:21|