|April 24, 2013, 06:09||
How to simulate mixture model in cooling tower
Join Date: Feb 2013
Posts: 10Rep Power: 5
Hi friends, I have some questions about mixture model (euler approach).
I'm mechanical engineering student in last semester. Now, I'm doing my final project. It's about modelling induced draft cooling tower. My model don't use packing/fill, so directly air contact with water droplets.
Actually, I built my project not in 3D but in 2D. So, water droplets spray came from left and right upper side and it fall. Air is entering from bottom side, and directly it contact both of them.
Friends, how to use cfd fluent to model my project. I did some trial error, but it didn't work.
In boundary conditions button what will I do? Can I model heat transfer?
Last edited by harkerz; April 25, 2013 at 07:19. Reason: additional
|Thread||Thread Starter||Forum||Replies||Last Post|
|Modelling Sand erosion using Mixture model and DPM||karlchapman||FLUENT||3||July 5, 2012 08:55|
|Mixture model||priyanka.asp||FLUENT||4||February 3, 2011 17:20|
|Cooling Tower||Roberto||FLUENT||8||July 22, 2009 03:16|
|Evaporation of droplets in cooling tower @cfx10-11||Mauricio Labarca||CFX||0||March 28, 2008 21:02|
|PDF combustion model to simulate reaction of gas i||Mark||FLUENT||0||August 4, 2001 11:07|