 |
 |
 |
|
|
|
[Sponsors] | ||||
April 29, 2013, 12:57
|
can't converge in FLUENT
|
#1 |
|
New Member
tita
Join Date: Apr 2013
Posts: 27
Rep Power: 13  |
Hi, all,
I run my mesh in the FLUENT, but it cannot converge. I have tried many times. Does anyone know why? And what is related to my converge? I have convergence critia is 0.5, it could converge, but is it too large? I am looking forward to your reply. Thanks in advance |
|
|
|
|
|
April 30, 2013, 02:47
|
|
#2 |
|
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
You need to give us more information. Post a picture of your domain, your grid and the residuals. Write something about your Fluent settings.
__________________
The skeleton ran out of shampoo in the shower. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
| heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 06:22 |
| Results are different for Ansys Fluent 14.0 and Fluent 6.3 | syavash | Fluent UDF and Scheme Programming | 1 | February 17, 2013 01:09 |
| k and epsilon were hard to converge in multiphase model of Fluent | Yanlong Li | ANSYS | 0 | January 2, 2013 05:25 |
| Alias problem when starting FLUENT from command line | batch_error | FLUENT | 0 | May 24, 2012 08:20 |
Linear Mode
