FLUENT boundary condition problem with gmsh
Hello.
I created a meshed geometry using the software gmsh. I created physical zones in gmsh as zell so that I would be able to define boundary conditions in FLUENT. I saved the file as .bdf before importing it into FLUENT then saving it as a .cas file. The boundaries are shown in FLUENT but I am unable to edit the boundary conditions i.e no slip wall The FLUENT toolbox writes "This page is not applicable under the current settings" Is there any setting I can change in FLUENT so that I can edit the boundary conditions? Thank you :) I found a solution to this problem. I used ICEM to create the geometry instead. |
All times are GMT -4. The time now is 20:09. |