 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2013, 10:33
|
Heat source
|
#1 |
|
New Member
Join Date: May 2013
Posts: 1
Rep Power: 0  |
Hi,
How do you create a heat source in fluent? I am trying to create one within the model, to represent fire within a 3d model of a pipe. I am not sure how to go about this as I am still new to fluent any help would be greatly appreciated. |
|
|
|
|
|
May 7, 2013, 11:36
|
|
#2 |
|
Member
Stephan Langenberg
Join Date: Sep 2011
Location: Germany
Posts: 73
Rep Power: 14 |
Maybe the easiest possibility is defining the Cel Zone Condition.
1. Energy Equation set on. 2. Activate source therms in your Cell Zone 3. Define the source therm (Energy). - This might only be possible in solid and fluid cell zones. |
|
|
|
|
|
 |
| Tags |
| fluent, heat source |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
| [swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
| Heat source Inetsity (W/m3)-Moving | Sami.Sawalha | ANSYS | 0 | February 17, 2013 02:35 |
| [swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 05:18 |
| UDFs for Scalar Eqn - Fluid/Solid HT | Greg Perkins | FLUENT | 0 | October 11, 2000 03:43 |
Linear Mode
