 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2013, 14:34
|
Setup question
|
#1 |
|
Member
Arthur Loginow
Join Date: Aug 2012
Posts: 99
Rep Power: 13  |
Hello, I want to try the following, but first I would like to hear an opinion, If i set the inlet and outlet to be pressure based and both have the same value theoretically there should be no translation of the fluid from the inlet to the outlet, but I want to do this because i want to try a pair of rotatory walls to see if the can move the fluid, my question is, would this work? It sounds like it should but I am not too sure about it.
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| question about uds | tanven | FLUENT | 2 | July 5, 2015 11:22 |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
| checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 12:34 |
| Question about Table applicaiton. | universez | OpenFOAM Running, Solving & CFD | 0 | January 12, 2010 20:31 |
| Poisson Solver question | Suresh | Main CFD Forum | 3 | August 12, 2005 04:37 |
Linear Mode
