Problem in meshing the spillway in Gambit -- CFD Online Discussion Forums

Today, 11:33

Problem in meshing the spillway in Gambit

flow_CH

Member

Join Date: Jan 2013

Posts: 47

Rep Power: 2

Hello

I am simulating a ogee spillway with aeration duct into the ramp in FLUENT.
Can you answer me how i should define the grids into the Gambit since
with consider the aeration duct, it is hard to me to define the grids,
because the aerator duct remain out of the boundary zone and the air can not enter it. Please see
attached image.
Thanks

Attached Images

	6666.jpg (82.8 KB, 0 views)
	profile.jpg (79.7 KB, 0 views)

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 05:22
Gambit meshing problem	David Banks	Main CFD Forum	0	July 19, 2007 11:48
Problem starting Gambit	ViHAR MALViYA	FLUENT	0	November 10, 2006 10:26
GAMBIT meshing problem for boundary layer	Falah	FLUENT	1	October 9, 2006 03:32
Gambit Meshing Problem	Drew	FLUENT	3	April 1, 2005 09:50

All times are GMT -4. The time now is 17:54.