|May 16, 2013, 07:45||
Linking boundaries special case
Join Date: Apr 2013
Posts: 18Rep Power: 4
Dear forum members i am new to this forum,
At the moment i am busy with a modeling a special nozzle in 2d, In reality this nozzle has a tube connecting the one side the other other side to allow acoustic compression and decompression waves to travel from one side to the other. Because it is a 2d simulation i don't want to simulate the tube outside the nozzle as it will interfere with the entailment of the airflow from the side of the nozzle. My question is can i link the boundaries inside the nozzle so that what comes goes out the top enters the bottom and visa versa.
the next question would be can i force a time delay to represent the length of the tube as these are acoustic waves?
thnx for the help in advance
Ps. i can upload a schematic of my mesh to explain it beter if you don't understand what i mean. I am working in ICEM and Fluent as i am relative new to the programs i only know how to use these atm
Last edited by Tarano; May 16, 2013 at 08:22.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Setting Flow/Pressure Boundaries in Floworks||Eran||FloEFD, FloWorks & FloTHERM||3||August 11, 2009 04:23|
|periodic boundaries - flow through a net||PK||FLUENT||0||July 12, 2007 11:58|
|Periodic Boundaries in GAMBIT!!||swetha||FLUENT||1||November 26, 2006 23:02|
|OpenFOAM with Cygwin||kitchener||OpenFOAM Installation||6||April 24, 2006 23:09|
|mass flux correction at outflow boundaries||Subhra Datta||Main CFD Forum||2||November 24, 2003 14:11|