CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   coal combustion (http://www.cfd-online.com/Forums/fluent/117873-coal-combustion.html)

semo May 16, 2013 11:25

coal combustion
 
Hello,

I am modeling coal combustion with non-premixed combustion and dpm. I am checking fluxes after the calculation. Mass flow balances out and shows the correct flows including the coal particles. however, when I check the heat transfer it shows less heat input from the dpm. Coal flow is 400,000 lb/h (mass flow is correct) and Coal HHV is 10,000 btu/lb (this value entered in coal calculator) so I should have 4,000mmbtu/hr heat input from dpm. Instead it shows me only 1,000mmbtu/hr from dpm.

FYI I am providing more than enough air to complete the combustion.

Any ideas?

Thank you in advance.


All times are GMT -4. The time now is 10:29.