|
[Sponsors] |
May 21, 2013, 01:59 |
sand inside cylinder
|
#1 |
Member
tang
Join Date: Jan 2013
Posts: 35
Rep Power: 13 |
hi,
can anyone teach me how to initial sand inside the cylinder in fluent?? |
|
May 22, 2013, 12:59 |
|
#2 |
Senior Member
A-A Azarafza
Join Date: Jan 2013
Posts: 226
Rep Power: 14 |
If you mean to add a solid phase in your model, just select the zone from initialization and patch the value for solid mass fraction. It'll work. One more thing, if you didn't already define a zone for this, use adapt tool and mark the interest zone.
__________________
Regard yours |
|
May 23, 2013, 03:12 |
cfd- post
|
#3 |
Member
tang
Join Date: Jan 2013
Posts: 35
Rep Power: 13 |
my situation is there are two buried pipe ; water pipe and gas pipe. The water pipe leak cause the water flow erosion the gas pipe.
I already patch the sand domain in volume fraction 0.95. However, when i open the cfd-post, why not have streamline between water leakage hole towards the gas pipe?? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
benchmark: flow over a circular cylinder | goodegg | Main CFD Forum | 12 | January 22, 2013 11:47 |
Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 06:24 |
[blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |
rotating cylinder using sliding mesh | Tim Daly | FLUENT | 1 | November 9, 2008 23:02 |
Turbulent steady flow around a circular cylinder | Mirek Kabacinski | FLUENT | 0 | July 23, 2003 18:40 |