|
[Sponsors] |
May 27, 2013, 10:02 |
Batch Mode
|
#1 |
New Member
Cristiano
Join Date: Feb 2013
Posts: 11
Rep Power: 13 |
Hi,
I sent a simulation in bentch mode on the server, but didn't use autosave. Now I would see if everithing is ok. Somebody know how is possible to open the simulation? Is it possible? Thanks |
|
May 27, 2013, 11:03 |
|
#2 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
When you submit a job using the cluster, you can't just interact with fluent when you simulation are running. you have to wait til everything finishes.
cancel the job , open the case , activate the autosave, and launch again |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 12:11 |
to run a replayfile in batch mode from UNIX | froztbear | ANSYS Meshing & Geometry | 4 | May 13, 2014 08:00 |
cfdpost in batch mode | taichijulie | CFX | 1 | October 25, 2010 15:29 |
double precision for batch mode | Lawrence | STAR-CD | 2 | April 7, 2010 19:10 |
Prosurf in batch mode | Dhruv | Siemens | 1 | September 19, 2005 18:02 |