|
[Sponsors] |
May 28, 2013, 04:05 |
How to set INTERIOR boco by TUI?
|
#1 |
Member
Join Date: Dec 2009
Location: China
Posts: 79
Rep Power: 16 |
Hi all,
I want to set a zone to interior bc by TUI. When I type /define/boundary-conditions there isn't a command of "interior" as mentioned in the TUI help file. There are only commands as shown below. /define/boundary-conditions> bc-settings/ pressure-outlet copy-bc target-mass-flow-rate-settings/ fluid velocity-inlet list-zones wall modify-zones/ zone-name non-reflecting-bc/ zone-type So, why there isn't a "interior" command? how can I get it... thanks in advance. PS: the version of FLUENT is 14.5 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Question about the use of ICEM tcl scripting | lnk | ANSYS Meshing & Geometry | 9 | January 16, 2013 09:24 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
$FOAM_USER_APPBIN & LIBBIN variables not set | rassilon | OpenFOAM Installation | 2 | February 16, 2010 20:54 |
Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 06:43 |
Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 04:27 |