|
[Sponsors] |
June 2, 2013, 22:42 |
set up the control volume
|
#1 |
New Member
michelle
Join Date: Jun 2013
Posts: 7
Rep Power: 12 |
in my case, i have the compartment which is already shell; have inlet and outlet hole, have floor to cover the lower part (cover the shell), have fuel cell engine (rectangular box), 1st fan (circle surface) at the front of the fuel cell as intake fan, 2nd fan (circle surface) at the back of fuel cell engine as exhaust fan. i have done 'fill' in design modeler to get the air domain and i did it. what should i do to do the next step? is it the boolean (substract) or surpress?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] ICEM Scripting Issues | tylerplowright | ANSYS Meshing & Geometry | 33 | September 27, 2021 17:35 |
set up of volume fraction of the thrid phase in VOF | fevi84 | FLUENT | 0 | April 27, 2012 18:22 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
How to set volume fraction in two phase flow | Kamel | FLUENT | 2 | March 23, 2007 01:06 |
Volume Loss in Level Set Method | Zi-Wei Chiou | Main CFD Forum | 6 | September 19, 2001 10:37 |