CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   centrifugal compressor analysis (http://www.cfd-online.com/Forums/fluent/118775-centrifugal-compressor-analysis.html)

farzadmech88 June 4, 2013 05:34

centrifugal compressor analysis
 
2 Attachment(s)
Dear all
this is Farzad, and I want ti simulate a centrifugal compressor, but I have some problems.
I use blade-generator and I exported it to design-modeler,I mesh it, now I face a problem in fluent(solver) sectio.
1- I use MRF , but I don't know the exact rotation direction, is it (Z) or (-Z)?

2- in tutorials they use oressur inlet and pressure outlet, why? do we must know these quantities?

3- after all when I run calculations, after few iterations I observe REVERSED FLOW.

I appreciate your helps in advance.
Farzad

farzadmech88 June 4, 2013 05:39

this is my mail problem:

""
I am doing CFD analysis of compressor in FLUENT.
but i am facing the problem of REVERSED FLOW at inlet as well as outlet with Pressure outlet condition.
i am using density based solver.Is it appropriate??
If i am using IDEAL GAS as fluid then it shows very large values of ranges pressure, temperature and velocity.""


All times are GMT -4. The time now is 23:45.