CFD Online URL
[Sponsors]
Home > Forums > FLUENT

Rotating Setup Doubt

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   June 15, 2013, 19:31
Default Doubt about Rotatory Analysis Setup
  #1
Senior Member
 
Arthur Loginow
Join Date: Aug 2012
Posts: 102
Rep Power: 4
Maralady is on a distinguished road
Hello, greetings to all, imagine that the following geometry is a volume of fluid, and it has 2 inner cylinders rotating in opposite directions, inside of it, my question is, how would you setup this particular model? I am asking this because so far, the only thing that I did was to specify that both cylinders are walls that are rotating, that is all, but I am not so sure that that is right. Any help will be more than appreciated.

Thanks
Attached Images
File Type: png Front View.png (28.5 KB, 3 views)
File Type: png Isometric.png (56.1 KB, 2 views)

Last edited by Maralady; June 15, 2013 at 21:46.
Maralady is offline   Reply With Quote

Old   June 15, 2013, 20:54
Default
  #2
Senior Member
 
Arthur Loginow
Join Date: Aug 2012
Posts: 102
Rep Power: 4
Maralady is on a distinguished road
My doubt here, is that I have 2 rotating axis, but just 1 volume, therefore I should not use MRF, but I should not use SRF either, I have just 1 cell zone, with 2 rotating axis, that makes it pretty confusing.
Maralady is offline   Reply With Quote

Old   June 15, 2013, 20:54
Default
  #3
Senior Member
 
Arthur Loginow
Join Date: Aug 2012
Posts: 102
Rep Power: 4
Maralady is on a distinguished road
I tried some tests with the set up of the walls, and it gave me some logic results, but again, I am not sure if that procedure is correct.
Maralady is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ICEM] Hexa mesh, curve mesh setup, bunching law Anorky ANSYS Meshing & Geometry 4 November 12, 2014 01:27
rotating and vibration setup liuzexiang CFX 2 January 30, 2013 17:41
Rotating Impeller Naith FloEFD, FloWorks & FloTHERM 22 November 5, 2012 09:53
Best choice for my setup ? Sliding mesh or single rotating ref frame ? Rockda FLUENT 0 August 23, 2011 06:05
Please help Single rotating frame Setup jaswi OpenFOAM Running, Solving & CFD 0 June 8, 2007 09:24


All times are GMT -4. The time now is 18:16.