CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Creating (http://www.cfd-online.com/Forums/fluent/119451-creating.html)

siddhant June 17, 2013 21:18

Creating
 
Hi, I am new to CFD and Fluent and I am trying to analyze Onera M6 wing. I downloaded the mesh from here http://www.grc.nasa.gov/WWW/wind/val.../m6wing01.html

It was created using PLOT3D, I believe.
Now, the problem I am facing is that when I read this file into Fluent, it generates only two zones by default: exterior and interior. Is there a way to create new zones (especially to define velocity-inlet) in Fluent? Any help is greatly appreciated. Thanks!


All times are GMT -4. The time now is 20:31.