|June 17, 2013, 21:18||
Join Date: Jun 2013
Posts: 1Rep Power: 0
Hi, I am new to CFD and Fluent and I am trying to analyze Onera M6 wing. I downloaded the mesh from here http://www.grc.nasa.gov/WWW/wind/val.../m6wing01.html
It was created using PLOT3D, I believe.
Now, the problem I am facing is that when I read this file into Fluent, it generates only two zones by default: exterior and interior. Is there a way to create new zones (especially to define velocity-inlet) in Fluent? Any help is greatly appreciated. Thanks!
|boundary conditions, fluent 14.5, onera m6, partition|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problems in creating a wedge type mesh||Joscha||OpenFOAM Native Meshers: blockMesh||27||November 3, 2015 12:27|
|Problem in running ICEM grid in Openfoam||Tarak||OpenFOAM||6||September 9, 2011 17:51|
|Using createPatch in place of couplePatches||sripplinger||OpenFOAM Mesh Utilities||8||November 13, 2009 08:14|
|Problems with Meshing: Collapsed Cells||Emmanuel Resch||CD-adapco||1||July 30, 2007 03:02|
|Gerris software installation||mer||Main CFD Forum||2||November 12, 2005 09:50|