 |
 |
 |
|
|
|
[Sponsors] | ||||
June 19, 2013, 10:03
|
fluent convergence
|
#1 |
|
New Member
Sarthak Nigam
Join Date: Jun 2013
Posts: 7
Rep Power: 12  |
Hi,
I made models of tubes with different diameters keeping the flow rates the same in all of them. I used standard k-epsilon model in my simulation, but still the solution converges for low diameters and does not for higher diameters. Although on reducing the mesh density on higher diameter models, It again starts converging. Can anyone please tell me why this is happening?? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| convergence in transient analysis using FLUENT | sumeet kotak | FLUENT | 31 | December 10, 2023 13:02 |
| Fluent Adjoint Solver Convergence Issue? | ex10148 | FLUENT | 2 | July 25, 2016 14:41 |
| convergence problem with FLUENT cavitation model | Belete Kiflie | FLUENT | 3 | February 20, 2006 10:16 |
| Standard convergence limit in FLUENT 6.1 | Henrik Ström | FLUENT | 3 | December 20, 2005 08:48 |
| CONVERGENCE IN FLUENT | Fer | Main CFD Forum | 6 | November 17, 2005 02:34 |
Linear Mode
