|July 3, 2013, 13:25||
How to Control the Fluid Level on a Tank
Join Date: Jul 2013
Posts: 2Rep Power: 0
I'm simulating a tank in which water and oil enters trough an inlet located at the bottom, and there are two outlets; one placed at the top of the tank for oil, and one at the bottom for water. The question is: How do I fix a determined water level on Fluent?
An strategy that I found is that there is no water outlet, and they modify the source mass term for water, depending on the current volume of water in the tank and the targeted volume, to keep the determined level.
Can someone please elaborate more on the above strategy? or are there other ways to solve this issue?
|fixed level, fluent, separation tank|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problems of running Oscillating plate tutorial||vovogoal||CFX||17||December 30, 2014 05:00|
|cyclone separator particle tracking prob..||sakurabogoda||CFX||33||May 29, 2013 06:36|
|Level Set Method and Ghost Fluid Method||alvin11||Main CFD Forum||0||October 24, 2010 09:46|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|