Home > Forums > Software User Forums > ANSYS > FLUENT

Turbulence model in hypersonic flow

Updated Threads

Reply

Search this Thread

July 11, 2013, 11:23	Turbulence model in hypersonic flow	#1
ajmal New Member Ajmal Join Date: Jul 2013 Posts: 1 Rep Power: 0	I am solving flow on the cone at hypersonic speed but there are some problems in the results. so i want to help in following sections.. which turbulence model should be preferable?? what should be y+ to capture the boundary layer?? what should be the thermal conductivity to observe the temperature on the wall??? what should the value of Cp??? Should i use ideal gas??? Regards

Reply

Tags

hypersonic flow, turbulence modeling, wall y+

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbulence model for low Reynolds number flow?	Nokadu	Main CFD Forum	3	May 26, 2013 11:42
Advice on turbulence model for complex internal flow	JPBodner	Main CFD Forum	1	September 3, 2011 03:07
validating turbulence model on flow around a car	Pedro	CFX	1	February 20, 2008 16:32
turbulence model for oil flow thr' small gap	carno	Siemens	2	August 31, 2005 08:12
Turbulence Model for flow between corotating disk	Felipe	FLUENT	0	January 10, 2004 12:01

All times are GMT -4. The time now is 08:03.