|July 16, 2013, 04:26||
Join Date: Jun 2013
Posts: 50Rep Power: 4
Hi to all,
I am simulating continuous drying process using CFD technique.
Geometry : a grain entrance is in top of drying bin. Next to filling the bin, grain outlet (is in the bottom of bin) is opened to exit grains. although hot air entrance is in bottom section of drying bin. air exits from top section of drying bin. therefore we have two inlet boundary conditions(air inlet and grain inlet) and two outlet boundary conditions. It would be mentioned that next to filling the bin, grains enter the bin with a mass flow rate that leave it. In other words, grains have the same inlet mass flow rate and outlet one.
--Can I model these processes and boundary conditions with Fluent software?
--If it is yes, how?
|Thread||Thread Starter||Forum||Replies||Last Post|
|simulate the drying process||Valpress||FLUENT||7||December 3, 2015 06:19|
|Coupling of drying process and flow simulation||franzdrs||Main CFD Forum||0||April 29, 2013 14:11|
|problem in simulating porous drying process||benson621||ANSYS||7||December 16, 2011 15:59|
|Gypsum drying process||gerardosrez||CFX||0||November 28, 2010 18:56|
|CFD in drying process||Istadi||Main CFD Forum||0||July 21, 2000 04:18|