|July 18, 2013, 10:45||
k-e RNG Convergence Problem
Join Date: Jun 2012
Posts: 15Rep Power: 5
I have been simulating a flow in an angled orifice, The geometry is such that it causes the mesh to have low quality ( Final ICEM Quality: 0.3, ICEM Blocking Equiangle skewness: 0.3). I was able to obtain continuity e-5 and the rest e-8 convergence for k-e standard but k-e RNG is not going any lower than e-1 for continiuity and e-4 for the rest. Any suggestions?
I understand that k-e RNG is more difficult to converge compared to k-e standard, but I wonder if there is anything I can do about it!
|k-e model, rng turbulence models|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Force can not converge||colopolo||CFX||13||October 4, 2011 22:03|
|Submerged fin, Convergence problem||supermouniette||FLUENT||10||July 6, 2009 10:47|
|Convergence of CFX field in FSI analysis||nasdak||CFX||2||June 29, 2009 01:17|
|3D Fluid Flow Convergence problem||Emily||FLUENT||2||March 21, 2007 23:18|
|CONVERGENCE PROBLEM - oil boiler||MM||FLUENT||1||February 15, 2007 06:24|