 |
 |
 |
|
|
|
[Sponsors] | ||||
July 27, 2013, 05:08
|
convergence acheived but problem
|
#1 |
|
New Member
mohan krishna pulakunta
Join Date: Jul 2013
Location: india
Posts: 4
Rep Power: 12  |
i tried to simulate laminar flow in a small pipe of dia 5mm and length 26cm and the solution.
inlet vel 0.06m/s the pressure drop i am getting is 8pa but if u calculate analiticaly we get 20pa i dont understand where i am wrong please reply |
|
|
|
|
|
July 27, 2013, 06:36
|
|
#2 |
|
Member
Ali Mohamadi
Join Date: Aug 2012
Posts: 32
Rep Power: 13 |
what is your fluid? if your fluid is water, it cause because it needs more length to become fully developed.
|
|
|
|
|
|
|
July 27, 2013, 09:51
|
|
#3 |
|
New Member
mohan krishna pulakunta
Join Date: Jul 2013
Location: india
Posts: 4
Rep Power: 12 |
thank you very much
it didnt strike my head thank you |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| convergence problem when use pisoFoam, LES for wind tunnel case | Forrest_Lei | OpenFOAM | 3 | July 19, 2011 06:00 |
| convergence problem | commonyue | Main CFD Forum | 1 | December 1, 2009 03:54 |
| Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 01:17 |
| 3D Fluid Flow Convergence problem | Emily | FLUENT | 2 | March 21, 2007 22:18 |
| Non Convergence of 3D Heat transfer cfd problem | Balraj | Main CFD Forum | 3 | December 9, 2004 00:24 |
Linear Mode
