|August 5, 2013, 13:43||
Need help with irregular surface values
Join Date: Feb 2011
Posts: 48Rep Power: 6
Dear Fluent users,
Simple question, why do you think there are irregular pressure values on the surfaces in the pictures below?
Using RNG, enhanced wall treatment with yplus 1, tried second and third order schemes, constructed a block structured mesh and generated geometry using icem cfd.
Sorry for posting the message on this board because I had posted the same on the main cfd forum. This might be the right board for it. I could not delete the previous one.
|Thread||Thread Starter||Forum||Replies||Last Post|
|TimeVaryingMappedFixedValue||irishdave||OpenFOAM Running, Solving & CFD||28||May 28, 2015 13:37|
|Snap Precision to a STL Surface||malaboss||OpenFOAM Native Meshers: snappyHexMesh and Others||16||July 26, 2013 01:44|
|[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?||jash||ANSYS Meshing & Geometry||19||July 23, 2013 18:48|
|snappyHexMesh aborting||Tobi||OpenFOAM Native Meshers: snappyHexMesh and Others||0||November 10, 2010 04:23|
|Heat flux on a irregular surface||massimo||CD-adapco||5||December 11, 2002 06:55|