|August 7, 2013, 05:42||
Euler-Model with Phase Accretion
Join Date: Feb 2013
Posts: 11Rep Power: 5
I am running a simulation using the Euler-Euler-Model. I want to simulate the accretion of a film of water on a surface. As I use Fluent 14.0, I have to use the UDF provided by Ansys in the context of a tutorial.
So far it runs pretty well. But if i stop the simulation to make a check, I have problems when continuing with the latest case and data files. It still executes the Wall-Film-steps during the calculation, but there is no phase accretion anymore, viz. my wall film stays in its last saved state.
I tried to rebuild and reload the UDf. I also checked the boundary settings, everything looks OK.
Does anybody have an idea why this happens?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Eularian granular two phase model||Kelly||FLUENT||18||June 15, 2016 09:15|
|using interface with Euler multi phase model||karimi||Main CFD Forum||0||May 22, 2011 02:39|
|Discrete phase model in porous media||Pradeep||FLUENT||0||February 3, 2006 17:30|
|euler model||CN||FLUENT||0||July 4, 2005 16:35|
|two phase model - pressure||marcel||Main CFD Forum||3||September 8, 2003 09:25|