|
[Sponsors] |
August 20, 2013, 10:17 |
Continuity does not converge
|
#1 |
New Member
Join Date: Jul 2013
Posts: 18
Rep Power: 12 |
Hi people!
I am currently doing a very simple case on natural convection. Basically, I will have a fluid domain from a piping. The 2 faces will have different temperature (hot and cold face) and the circumferential face will be adiabatic. I am using k-epsilon model with enhanced wall treatment together with buoyancy effect and curvature correction. My y+ value is set to be 5. Y value is calculated from the max velocity ontained from the natural convection and ANSYS Mesh is used. I have tried several time but I cannot seem to have the continuity converged. May I know what are some of the possible issue which i can look into? Thank you for your time. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMI interDyMFoam for mixer nu problem | danny123 | OpenFOAM Programming & Development | 8 | September 6, 2013 02:34 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |