|
[Sponsors] |
September 1, 2013, 04:58 |
Make-periodic to 3-D dimpled pipe
|
#1 |
New Member
Timmy Tang
Join Date: Nov 2012
Posts: 2
Rep Power: 0 |
I'm making a 3-D dimpled pipe. When i made periodic zone to Inlet and outlet the wall, there is an error message said.
" Warning: different number of faces on these threads. computed translation deltas: 0.000041 0.000004 -0.319994 zone 6: matched 0 out of 1174 faces. zone 7: matched 0 out of 1142 faces" I am not sure if it is because of the geometry. If i solve it without doing periodic, the result is correct. Can anyone give me some suggestions |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why can't I make the boundaries periodic? | Alina | FLUENT | 5 | April 12, 2012 15:06 |
LES of periodic pipe centerline turbulent kinetic energy | smehdi609 | OpenFOAM | 0 | December 1, 2010 00:59 |
How to make pipe flow in 2D? | ufirsthc | Main CFD Forum | 1 | April 27, 2010 02:29 |
SimpleFoam pipe flow velocity blowup | gzink | OpenFOAM Running, Solving & CFD | 0 | June 9, 2006 17:52 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 22:31 |