|September 1, 2013, 03:58||
Make-periodic to 3-D dimpled pipe
Join Date: Nov 2012
Posts: 2Rep Power: 0
I'm making a 3-D dimpled pipe. When i made periodic zone to Inlet and outlet the wall, there is an error message said.
" Warning: different number of faces on these threads.
computed translation deltas: 0.000041 0.000004 -0.319994
zone 6: matched 0 out of 1174 faces.
zone 7: matched 0 out of 1142 faces"
I am not sure if it is because of the geometry. If i solve it without doing periodic, the result is correct.
Can anyone give me some suggestions
|Thread||Thread Starter||Forum||Replies||Last Post|
|Why can't I make the boundaries periodic?||Alina||FLUENT||5||April 12, 2012 14:06|
|LES of periodic pipe centerline turbulent kinetic energy||smehdi609||OpenFOAM||0||December 1, 2010 00:59|
|How to make pipe flow in 2D?||ufirsthc||Main CFD Forum||1||April 27, 2010 01:29|
|SimpleFoam pipe flow velocity blowup||gzink||OpenFOAM Running, Solving & CFD||0||June 9, 2006 16:52|
|fluid flow fundas||ram||Main CFD Forum||5||June 17, 2000 21:31|