|September 12, 2013, 13:21||
Convergence problem Fluent refined mesh
Join Date: Sep 2013
Posts: 14Rep Power: 5
[I've done a cylinder of 400m. I've done a mesh of 7 cm t-grid and my problem converged. Now I've scaled the cylinder using a ratio 1 : 20 but there are residual oscillations. These are shown in the image ATTACH]25320[/ATTACH].
I'm using k epsilon standard and my problem is steady. So how can I resolve this problem?
|September 14, 2013, 16:35||
Join Date: Dec 2012
Posts: 46Rep Power: 5
Also, ensure you scaled before setting up the rest of your case so that your boundary conditions don't get mismatched (they shouldn't, but the Fluent documentation recommends it).
Find me online here.
Last edited by jdrch; September 15, 2013 at 13:50.
|convergence, oscillation, refined mesh, residual|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Convergence problem when refine the mesh...||TB||CFX||31||August 31, 2016 19:02|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|[Other] Mesh Importing Problem||cuteapathy||ANSYS Meshing & Geometry||1||June 7, 2012 13:39|
|early stall, poor convergence, and mesh quality||everest||CFX||2||May 12, 2010 16:27|
|Re: Convergence problem for refined grid||CFD_Novice||Main CFD Forum||13||February 17, 2008 23:56|