|September 16, 2013, 06:27||
Create a multi-bosy part
Join Date: Sep 2013
Posts: 24Rep Power: 3
I am currently trying to make a 2D model of a Carbon storage saline aquifer. The aim is to monitor CO2 migration to the ocean surface. To begin I am only doing a few layers. The first layer will be the ocean, the second layer will be a porous medium representing the earth's crust, and the third layer will be CO2.
So far I have sketched the geometry and created 3 parts, I have then mapped face meshed, and named each layer/part as well as the ocean surface that I have called OUTLET.
I hope that when I reach setup I can assign separate materials to the separate bodies, would I be right in thinking this?
On loading setup I get an error "Model Information is incompatible with incoming mesh". Do I have to create a multi-body part and if so how do I go about that? I have seen on other threads that you just right cvlick the tree, but I only get the options:
Suppress Surface Bodies
Any advice would me more than appreciated!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Create a "triangular box" with blockMesh||voingiappone||OpenFOAM Native Meshers: blockMesh||4||May 22, 2015 02:22|
|[DesignModeler] Newbie - Create Region||5746085||ANSYS Meshing & Geometry||2||March 12, 2012 14:15|
|Actuator disk model||audrich||FLUENT||0||September 21, 2009 07:06|
|Where's the singularity/mesh flaw?||audrich||FLUENT||3||August 4, 2009 01:07|
|Any other way of converting a multi part to a single part avoiding ANSYS Design Model||LusoMundo||ANSYS Meshing & Geometry||1||May 14, 2009 14:35|