CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   axisymmetric post-processing (http://www.cfd-online.com/Forums/fluent/124136-axisymmetric-post-processing.html)

iman_hn September 28, 2013 01:45

axisymmetric post-processing
 
Is it possible when dealing with 2d axisymmetric, to post-processing the results in a 3d view? How does it work?

ghost82 September 28, 2013 05:49

I think it's not possible in fluent post processing, but I remember it can be done in cfd-post if I remember well..
In fluent, as I know, you can only display the "other half" of the geometry by mirroring in respect to the axis.

Daniele

iman_hn September 28, 2013 14:25

Thank you for your reply Mr.Daniele
I think, you are exactly right about displaying the other half in fluent. do you know about post processing in CFD post for 3d view of axisymmetric model?

oj.bulmer October 16, 2013 11:11

If I remember correctly, FLUENT 2D axisymmetric case is shown as a 3D wedge in CFD Post (Check). If yes, you can use a rotational symmetry to display the whole cylindrical model.


All times are GMT -4. The time now is 23:29.