Home > Forums > Software User Forums > ANSYS > FLUENT

Negative Drag on Airfoil

Updated Threads

Reply

Search this Thread

October 1, 2013, 06:23	Negative Drag on Airfoil	#1
jasonbot Member Jason Join Date: May 2013 Location: South Africa Posts: 32 Rep Power: 12	I am getting relatively accurate Lift measurements but my drag values are all negative for my airfoil. I have tried a number of turbulence models and all give the negative drag. I have obtained some form of mesh independence by using the Adapt Gradient tools. I think I might have a problem with my reference values? Does anyone know how I could change my coordinate system?

Reply

Tags

airfoil, ansys, lift, negative drag

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Airfoil negative drag coefficent	James Forrest	Main CFD Forum	9	September 5, 2022 10:30
[blockMesh] non-orthogonal faces and incorrect orientation?	nennbs	OpenFOAM Meshing & Mesh Conversion	7	April 17, 2013 05:42
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

All times are GMT -4. The time now is 02:44.