CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   [Design Modeler] Stirred Tank using MRF (http://www.cfd-online.com/Forums/fluent/124460-design-modeler-stirred-tank-using-mrf.html)

gurpreet89 October 5, 2013 08:49

[Design Modeler] Stirred Tank using MRF
 
hi friends
i am doing a project on stirred tank for my post graduation theses but i am totally new to Ansys. i have made my geometry in design modeler and created interface between rotating region(impeller) and stationary region(fluid) but when i run it in fluent using MRF it shows
"Note: zone-surface: cannot create surface from sliding interface zone.
Creating empty surface."
i am not sure whether my geometry is incorrect or i am applying wrong boundary conditions
plz help

jdrch October 5, 2013 16:02

It sounds like you have both MRF and sliding mesh enabled somehow. Check your boundary and cell zone conditions to ensure they are all MRF and not sliding mesh.

gurpreet89 October 6, 2013 14:02

thanks for the reply!..


All times are GMT -4. The time now is 14:05.