|
[Sponsors] |
December 17, 2013, 00:37 |
negative volume exists error
|
#1 |
New Member
P NAGA SURESH KUMAR
Join Date: Oct 2013
Location: HYDERABAD
Posts: 6
Rep Power: 12 |
i was new to fluent when i was working on dynamic meshing on IC engine. Initially dynamic mesh was working but nearly at 210 crank angle it was showing "negative volume error". at this crank angle the minimum orthogonal quality is zero. i think it may be the reason. can any one suggest me how to overcome it.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem of simulating of small droplet with radius of 2mm | liguifan | OpenFOAM Running, Solving & CFD | 5 | June 3, 2014 02:53 |
Errors in UDF | shashank312 | Fluent UDF and Scheme Programming | 6 | May 30, 2013 20:30 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |