|
[Sponsors] |
October 14, 2013, 11:30 |
Turbulence parameters and convergence
|
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
I have observed that turbulent parameters played a major role in the convergence of a simulation. Initially when I simulated with the default values of intensity ans viscosity ratio (5 and 10) the convergence is bad and when I switched over to use intensity and hydraulic diameter (= 4A/P) there is an improvement in the convergence.
Could some one please provide a reasoning to this behavior
__________________
Best regards, Santhosh. |
|
October 14, 2013, 12:52 |
|
#2 |
Super Moderator
|
might be it is due to fact that you are giving parameters resembling the real physics in the latter case !!!
But you can manipulate to get the equivalent parameters for all options and you would probably get same convergence behaviour !!! |
|
October 14, 2013, 14:41 |
|
#3 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
In many cases it is not possible to have an understanding of the turbulence parameters to be used and how to identify if the convergence problem is due to the turbulence settings
__________________
Best regards, Santhosh. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turbulence parameters and convergence | saisanthoshm88 | CFX | 3 | October 15, 2013 06:00 |
Convergence of turbulence transport equations | KK | CFX | 0 | January 31, 2008 20:46 |
Do you know of any tweaks of the solver parameters to accelerate solution convergence | sek | OpenFOAM Running, Solving & CFD | 0 | September 15, 2006 13:45 |
convergence parameters | amv | Phoenics | 4 | September 21, 2005 06:49 |
turbulence convergence | irfan | Siemens | 1 | November 19, 2002 04:38 |