 |
 |
 |
|
|
|
[Sponsors] | ||||
October 15, 2013, 06:11
|
a question of the DO radiation model
|
#1 |
|
New Member
tjut-wx
Join Date: May 2009
Posts: 14
Rep Power: 16  |
Hi, I used the DO radiation model in FLUENT to model the light source irradiation, and the lamp wall was set to semi-transparent media, and the value of direct irradiation was set to 130 W/m2. After the calculation was done, the contour value at the lamp surface was displayed around the value of 2000 W/m2. My question is: what is the specific meaning of "incident radiation" ? Thanks!
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solver refuses to run: Monte Carlo Radiation Model | Zaphod'sSecondHead | CFX | 9 | February 14, 2017 09:20 |
| Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
| question about turbulence model selection and sensitivity | karananand | Main CFD Forum | 1 | February 26, 2010 04:41 |
| Question about radiation | Flying | CFX | 0 | January 12, 2005 20:32 |
| How to use radiation model with porous model? | jacky | CFX | 0 | December 17, 2002 22:51 |
Linear Mode
