 |
 |
 |
|
|
|
[Sponsors] | ||||
October 16, 2013, 04:21
|
using functions within parameters?
|
#1 |
|
New Member
Rich
Join Date: Sep 2013
Posts: 3
Rep Power: 12  |
Hello everyone!
A single Cell Zone of my mesh is going to be a porous zone. In CFX, there was only a single input parameter for this, the "Loss coefficient". For my case I am fairly sure that this is actually the inertial resistance, due to its units. I was wondering if it is possible, using an input parameter, to have a variable inertial resistance, using values from the iterations, such as the velocity at that point. Would I use a UDF? And in that case, which macro should I use? Thanks for the help! |
|
|
|
|
 |
| Tags |
| fluent, parameter, porous body, profile, udf |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pro/E to ANSYS Parameterization Guide | Trues | ANSYS | 4 | April 18, 2018 05:52 |
| [Commercial meshers] CCM+ Mesh Conversion | Ingenieur | OpenFOAM Meshing & Mesh Conversion | 17 | February 2, 2014 09:34 |
| Parameters rhoSimpleFoam | marcus85 | OpenFOAM Pre-Processing | 0 | May 15, 2013 09:36 |
| Turbulence model parameters and equations | Maximus91 | Main CFD Forum | 1 | October 24, 2012 13:20 |
| Parameters for multigrid solver | HaZe | OpenFOAM Running, Solving & CFD | 3 | January 28, 2012 02:05 |
Linear Mode
