 |
 |
 |
|
|
|
[Sponsors] | ||||
October 17, 2013, 09:42
|
Execute command to change boundary condition
|
#1 |
|
New Member
Aileen Magee
Join Date: Sep 2013
Posts: 24
Rep Power: 12  |
Hello,
I am modelling flow of a less dense fluid into tank full of a more dense fluid. I have defined the inlet zone as a velocity inlet and have set the desired velocity magnitude. The problem I am having is trying to change the velocity magnitude to zero after a certain number of time steps. I believe you use the execute command section within calculation activities, however I do not know what command to use. Any help would be appreciated! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Use DEFINE_ADJUST change boundary condition | liurengtong123 | Fluent UDF and Scheme Programming | 29 | January 14, 2024 00:56 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
| CFX fails to calculate a diffuser pipe flow | shenying0710 | CFX | 7 | March 26, 2013 04:13 |
| inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 08:56 |
Linear Mode
