|
[Sponsors] |
October 24, 2013, 12:59 |
Auto stop when converged?
|
#1 |
New Member
Join Date: Oct 2013
Posts: 2
Rep Power: 0 |
I am running some transient simulations and rather than running for the specified number of time steps, I would like them to run until they have converged, and then automatically stop and save the data once convergence has been reached. Is this possible?
|
|
October 28, 2013, 15:06 |
|
#2 |
Senior Member
Join Date: Mar 2009
Location: Indiana, US
Posts: 186
Rep Power: 17 |
Check for convergence over time during a transient simulation does not make sense.
The convergence has to occur for each time step which will imply that the transient run is converged. The transient run needs a hard stop defined such as time or no of TS. Regards Luke |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient DPM-About Start Stop times | Julie | FLUENT | 3 | January 24, 2014 08:39 |
command TUI / Scheme for stop and continue calculate | rayolau | FLUENT | 1 | May 13, 2013 11:20 |
New sixDoFRigidBody BC working with laplaceFaceDecomposition | Ya_Squall2010 | OpenFOAM Running, Solving & CFD | 13 | April 17, 2013 03:04 |
compiling firefoam | Farshad_Noravesh | OpenFOAM | 27 | December 24, 2012 05:21 |
FSI doesnt stop if i click stop button | peterputer | CFX | 7 | November 20, 2012 16:56 |