Display of Phase Graphic
Hi, I am working on a 3D simulation of a box dropping into a tank of water in FLUENT. After setting up all the boundary conditions and patching, I went to Graphics and Animations to check whether I have patched properly. While the partition of the water and air is correct, there were empty patches all around. In the picture below, the top view of the model is shown. Could anyone enlighten me on why these patches had surfaced? And would this affect my data collected?
Thank you :) http://i8.photobucket.com/albums/a45...sesPreview.jpg |
All times are GMT -4. The time now is 10:59. |