|
[Sponsors] |
November 3, 2013, 15:22 |
Extract data from a wind turbine blade
|
#1 |
New Member
Yuntian
Join Date: Sep 2013
Posts: 1
Rep Power: 0 |
I did a 3D run to solve for the flow around a wind turbine. Now I need to extract data at a particular spanwise location along the blade. I created a plane intersecting the blade, but am not sure how to extract data along the intersection line (of plane and strut). Any suggestions how to do this or any other approach?
Thanks a lot! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to run a wind turbine blade simulation | gerritgroot | SU2 | 6 | February 8, 2019 14:44 |
Verifying results for a wind turbine blade simulation in ANSYS CFX | Joystix | CFX | 3 | April 27, 2012 17:52 |
[GAMBIT] Meshing a wind turbine for wing tip vortexes | Grog106 | ANSYS Meshing & Geometry | 1 | March 29, 2012 06:07 |
Wind Turbine Experimental Data | naimishharpal | Main CFD Forum | 7 | May 1, 2011 22:48 |
Turbine Blade Data | Abhijeet | Main CFD Forum | 1 | June 25, 2002 05:28 |