|November 5, 2013, 10:52||
BC changes in steady and transient simulation
Join Date: Feb 2012
Posts: 83Rep Power: 6
I set a wall with various values of temperature as my BC and run my case in two different cases.steady and transient(results of steady will be initial for transient for better rate of convergence in transient) .The problem that I have in transient case, the temperature of wall increase by 20C which is not normal. BC should be the same in both cases.I was wondering if somebody knows the problem.
I use energy and momentum equations for my case.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem in initializing transient simulation with a finer mesh||sidd||CFX||8||April 29, 2016 02:25|
|Transient features in steady state simulation?||PedFr0||Main CFD Forum||16||October 10, 2013 07:17|
|Steady state simulation with transient partilcle tracking||mali28||FLUENT||2||February 7, 2013 15:25|
|Steady vs. Transient||egge24||FLUENT||3||January 14, 2012 00:49|
|Laminar gas flow under slight suction - transient works but not steady||audrey||CFX||1||September 8, 2011 19:43|