|November 6, 2013, 14:36||
Trouble getting current temperature in a UDF
Join Date: Sep 2013
Posts: 4Rep Power: 5
I'm trying to write a UDF that will apply a new temperature to a wall at each time step. However, I keep getting an error message whenever I attempt to use F_T(f,t) or C_T(c,t). Here is my UDF:
I keep getting the error:
"invalid type conversion: float -> pointer to char."
Does anyone know what this error message means and how to fix it?
|November 7, 2013, 10:51||
Join Date: Jun 2013
Posts: 16Rep Power: 5
In addition, replace 't' with 'T'.
At the begining of your UDF, the t is a thread not a temperature subsequent yet. This will clash.
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF to change heat transfer coefficient with wall temperature||emmkell||Fluent UDF and Scheme Programming||13||September 15, 2016 11:52|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|Inlet won't apply UDF and has temperature at 0K!||tccruise||Fluent UDF and Scheme Programming||2||September 14, 2012 06:08|
|UDF - Temperature adjustment||PaulK||FLUENT||1||July 16, 2010 15:09|
|UDF with Granular Temperature||meangreen||Fluent UDF and Scheme Programming||0||February 14, 2010 18:58|