|
[Sponsors] |
November 16, 2013, 06:13 |
problem with interfaces
|
#1 |
New Member
Artem
Join Date: Aug 2013
Posts: 15
Rep Power: 12 |
http://www.cfd-online.com/Forums/flu...interface.html
I have a similar problem. Four parts: 1 - stationary (supply) 2 - moving\rotating (inducer) 3 - moving\rotating (rotor) 4 - stationary (duct) After I set the interface in FLUENT, there appeared two walls in the place of the interface. Their type is solid (aluminum). In the end they interfere with the movement of flow. Can you help me? http://www.cfd-online.com/Forums/mem...517-fig-1.html http://www.cfd-online.com/Forums/mem...516-fig-2.html |
|
November 18, 2013, 02:50 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
post pictures please
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
Problem with Domain Interfaces | hagupta | CFX | 13 | May 5, 2006 12:41 |