 |
 |
 |
|
|
|
[Sponsors] | ||||
November 21, 2013, 04:52
|
chemkin file
|
#1 |
|
Senior Member
christine
Join Date: Jul 2009
Location: europe
Posts: 125
Rep Power: 16  |
Hello everyone,
I have a problem when importing chemkin files : Fluent refuses to open any file, even files I've already used and were ok. I always have messages like "error at line 1" or "error at line 49" (always 49 !!!) even if the line 49 does not exist in the chemkin file. I really don't understand because some of these Chemkin files were ok in the past and I've also tried with files downloaded from the net, without modifying them before. Does anyone has this problem? Thank you in advance. |
|
|
|
|
 |
| Tags |
| chemkin |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
| [swak4Foam] swak4Foam-groovyBC build problem | zxj160 | OpenFOAM Community Contributions | 18 | July 30, 2013 13:14 |
| [swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
| "parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
Linear Mode
